usually shouldn’t happen if the vacuum is functioning correctly, but may be the cause if you’ve been vacuuming for a long time without letting it cool down.. Switch off the vacuum and allow it to cool for 24 hours, then try using it again.
In most cases, small patches of dust and dirt won’t have a big impact on your vacuum’s performance.Cleaning them makes your vacuum look more attractive and prevents the dirt from causing future clogs though..
If you notice any larger clogs, then you’ll need to make sure they are removed.Loose clogs can often be removed by hand, although you may need to use a narrow brush or compressed air for awkward locations.. Where to Check for Clogging.Some of the most common locations for clogs include:.
Where the wand meets the vacuum body on a stick vacuum.The entrance to the main tube from the floorhead.
The inside of the hose (see step three).
The gap between the filter and the edge of the dust bin (for cyclonic vacuums).Step 1: Remove the Multi Mk2’s Bin.
The Gtech Multi Mk2’s filter is located inside the main cylinder.To access it, you first need to remove the bin..
Unlike many vacuums, there isn’t a button to remove the bin.Instead, you just pull it away from the vacuum’s body.. We’ve found the bin can sometimes be a bit stiff – especially if you have a new Gtech – so you might need to wiggle it a bit.. Related Article:.
(Editor: Rechargeable Shelves)